Buying/locating the clear indicator lenses:
I bought my red and clear units from eBay from a company called Intercare Trading - they're based in Germany and the shipping is pretty fast!
Fitting the rear light units:
The only tool you need for this is an 8mm socket set!
A quick before pic (nothing special just standard OEM rear light units with amber indicators):
STEP 1:
Open the boot and look at the back of the rear light cluster. You should be familiar with this if you've ever had to change a bulb:
STEP 2:
Twist the plastic locking bolt anti-clockwise - once unscrewed you can pull the assembly back (note that the plastic bolt does not come completely away from the unit) - you can lift up the rear carpet to allow you to lengthen the wiring room slightly if required:
STEP 3:
Now you have removed the rear panel - it would be a good time to change the indicator bulb - change this for an amber or silver (amber) unit:
STEP 4:
The rear light unit is only held in place with 2 x 8mm bolts - these are highlighted in the picture below and are easily removed:
STEP 5:
Complete STEP 2 - STEP 4 for the other side - you should now have both units removed from your car:
STEP 6:
Offer up the new/replacement unit to your car and feed the threaded bolt through the holes. I found it was easier to start at the top of the boot weather seal and work my way down, feeding the light unit in as I went. Once the unit is in place and flush with the rear bumper and rear wing then attach the 2 x 8mm bolts and tighten.
STEP 7:
Place the rear plastic cover back on and screw tight.
STEP 8:
Repeat STEP 6 and 7 for the other side.
JOB DONE!!!
